PDA

View Full Version : Konica Minolta Bizhub C253


Custom Search


Staggan
03-14-2017, 11:13 PM
Hello

I have a C253 showing a C0202 error...

It seemed to be a damaged lift motor, the plastic clips had snapped off the motor assembly allowing the end to fall off...

The motor has been replaced, but still getting the error...

I tried swapping the lift sensors between tray 1 and 2, but the fault remains with tray 1... There are, or appear to be no obstructions... certainly no paper jammed anywhere which is the normal cause of this issue....

Any suggestions?

Thanks

blackcat4866
03-14-2017, 11:30 PM
Do you get 24vdc to the lift motor when you close the tray? Does the motor run? =^..^=

Synthohol
03-14-2017, 11:46 PM
Try a trouble reset.

Staggan
03-15-2017, 08:08 AM
Tried trouble reset...

I'll check the voltage at the lift motor... and I can't hear the lift motor.. but that's no guarantee its not running....

Thanks

Custom Search