Replacement MFP

[antone]

Locked up invalid external error

Sent from my SM-N920V using Tapatalk

[blackcat4866]

It might help to know what hypothetical model of MFP this is. =^..^=

[Woxner]

what machine. are you saying you replaced a mfp board? and was it from another machine. did you try and do firmware and got this. little more info needed. i dont do mind reads on fridays

[allan]

Feels like a WTF thread. Why not just do that...
It break me up.

[KenB]

Locked up invalid external error

Sent from my SM-N920V using Tapatalk

36365

[antone]

Biz hub 654e..tryed 3 MFP boards...firmware updated to latest version....than hangs up and locked up..right there

Sent from my SM-N920V using Tapatalk

[Woxner]

if you used a board from a different machine then yeah you have a problem. you might use a reset tool to get this to boot up. your not supposed to swap pwb's. they back each other up and if the info is not the same it wont boot

[blackcat4866]

Have you tried initializing the MFP board? That would be required anyway, if perchance your boards were used. =^..^=

[antone]

Sounds good...how do you initialize the MFP

Sent from my SM-N920V using Tapatalk

[lahorebooks.lb]

Any one help me 5875
R2R3 stabling xerox

Sent from my QMobile Z8 using Tapatalk

[blackcat4866]

Any one help me 5875
R2R3 stabling xerox

Sent from my QMobile Z8 using Tapatalk

Perhaps you might like to start a new thread in the Xerox forum ... where the Xerox techs might read it, rather than hijacking Antone's thread in the Konica Minolta forum?
=^..^=