View Full Version : Replacement MFP
antone
04-14-2017, 06:40 PM
Locked up invalid external error
Sent from my SM-N920V using Tapatalk
blackcat4866
04-14-2017, 07:25 PM
It might help to know what hypothetical model of MFP this is. =^..^=
Woxner
04-14-2017, 07:26 PM
what machine. are you saying you replaced a mfp board? and was it from another machine. did you try and do firmware and got this. little more info needed. i dont do mind reads on fridays
allan
04-14-2017, 07:29 PM
Feels like a WTF thread. Why not just do that...
It break me up.
Locked up invalid external error
Sent from my SM-N920V using Tapatalk
36365
antone
04-15-2017, 01:00 AM
Biz hub 654e..tryed 3 MFP boards...firmware updated to latest version....than hangs up and locked up..right there
Sent from my SM-N920V using Tapatalk
Woxner
04-15-2017, 01:24 AM
if you used a board from a different machine then yeah you have a problem. you might use a reset tool to get this to boot up. your not supposed to swap pwb's. they back each other up and if the info is not the same it wont boot
blackcat4866
04-15-2017, 01:44 AM
Have you tried initializing the MFP board? That would be required anyway, if perchance your boards were used. =^..^=
antone
04-15-2017, 03:00 AM
Sounds good...how do you initialize the MFP
Sent from my SM-N920V using Tapatalk
lahorebooks.lb
04-15-2017, 11:33 AM
Any one help me 5875
R2R3 stabling xerox
Sent from my QMobile Z8 using Tapatalk
blackcat4866
04-15-2017, 12:41 PM
Any one help me 5875
R2R3 stabling xerox
Sent from my QMobile Z8 using Tapatalk
Perhaps you might like to start a new thread in the Xerox forum ... where the Xerox techs might read it, rather than hijacking Antone's thread in the Konica Minolta forum?
=^..^=
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.