PDA

View Full Version : Di2510 - Please Wait??


Custom Search


OutlawTorn
08-12-2008, 11:38 AM
Hello, I am having problems with a Di2510 machine. When it is turned on I get the 'Please Wait' screen, and then nothing? It just stays frozen on that message. I have tried umpteen warm resets on the machine, turning the power on and off - but nothing. Has anyone encountered this before? Am I looking at a PWB-A failure? Any help REALLY welcomed!

cheers.

fixthecopier
08-12-2008, 12:00 PM
The first thing is the flash card on the right side of the scanner. Swap it with another, if that works, rewrite your card. Next swap the card reader and then the MFB 3 that the card reader seats into. You may try unpluging and reseating these boards first. One of these will fix you.

OutlawTorn
08-12-2008, 04:56 PM
thanks for the reply fixthecopier, how do you find this sorry?

Scorotron Wizard
08-12-2008, 11:54 PM
Does the machine run any motors because a really common problem is the toner add gearbox chews up and the machine runs for 5 mins while it tries to add toner.

OutlawTorn
09-04-2008, 11:37 AM
Ok guys, HELP! I have replaced the toner hopper drive unit and cleared/re-installed the firmware onto the flashcard twice now. Still nothing. Should I purchase a new flashcard? do they get faulty?


Any help muchly appreciated, at a bit of a loss here!

perdana
09-05-2008, 03:48 AM
I think it was NV Ram.

OutlawTorn
09-05-2008, 09:08 AM
NV Ram? where do I locate this? could someone explain a little further? thank you.

Johnny_B500
09-05-2008, 04:42 PM
It's a faulty memory or scan chip by the NIC card. Remove one or the other to test.

OutlawTorn
09-08-2008, 12:14 PM
NIC card? is this the network card? could you explain a little further thank you?!

Johnny_B500
09-09-2008, 05:24 AM
I have found that this is usually caused by a defected SU-2 or Memory.

Firstly check the connection between the ROM board and the MFB3 board. If that doesn't help (in most cases ot doesn't) then remove the SU-2 or memory and see if the machine starts up and goes to the copy screen.

Hope this helps!

OutlawTorn
09-10-2008, 02:57 PM
Just wanted to say thanks for the help on this issue everyone! I ended up disconnecting the network card and re-seating it and this solved the problem. Weird, but hey, I'm happy. Cheers again.

Johnny_B500
09-11-2008, 01:35 AM
No problem and I'm glad you were able to resolve it!

copychef
09-11-2008, 03:02 AM
xxx

Custom Search