PDA

View Full Version : Help c8000


Custom Search


Shinigami
04-25-2017, 12:58 PM
36459

Hello everyone !

Can you help me ! I have this problem in konica minolta press C8000

Shinigami
04-25-2017, 01:54 PM
Up

Gaffers01
04-25-2017, 02:36 PM
fusing belt is knackered

Shinigami
04-25-2017, 05:21 PM
fusing belt is knackered


But i check it ! It's correctly installed

diananto
05-08-2017, 05:24 PM
Excuse me, is lower belt fusing its been replaced?
Maybe I've seen the same problems before..
The fusing lower belt was already saggy at the front and rear section,
I tried to replace the part and the problem gone.

diananto

Shinigami
05-08-2017, 06:17 PM
Excuse me, is lower belt fusing its been replaced?
Maybe I've seen the same problems before..
The fusing lower belt was already saggy at the front and rear section,
I tried to replace the part and the problem gone.

diananto


I replace the fusing lower belt ! But the same problem

diananto
05-09-2017, 03:04 AM
I replace the fusing lower belt ! But the same problem

In addition to lower fusing belt, which parts has been replaced?
Upper roller and outside heater, already?
maybe you have to replace the main fusing unit with the new one and
elimination one by one where is the problem maker.
I'm also still learning, just wanted to share a little, might help. :)

Shinigami
05-09-2017, 09:14 AM
In addition to lower fusing belt, which parts has been replaced?
Upper roller and outside heater, already?
maybe you have to replace the main fusing unit with the new one and
elimination one by one where is the problem maker.
I'm also still learning, just wanted to share a little, might help. :)

thank you so much ! i will tray with the haeters ! And fusing roller

Custom Search