If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Had a machine yesterday a B951 with J9352. The sensors and the wiring was all ok. It was caused by the ADU board(one one the left hand side).
Its not uncommon for the transport rollers to loose a bit of rubber and become to small to transport the paper in time.
Meaning smaller diameter means the paper does not travel fast enough and does not make it to the next sensor within the specified time.
The ADU Board has already been replaced but can not be processed.
First of all, I replaced the ADU ASSEMBLY completely with the equipment 1051, which was left in the office.
I plan to slowly inspect it later. Thank you.
Comment