PDA

View Full Version : Replacing fuser belt on C6500 & someone didn't replace "fusing jigs" .. now what?


Custom Search


jay3
06-02-2017, 02:04 AM
Bought this C6500 recently... was supported by KM since it was new. What kind of mfg's tech wouldn't put these jigs back? Sheesh.

What can I do in this situation?

jay3
06-02-2017, 02:21 AM
Just replying I found a solution... all those jigs do is hold down that springed bar to "loosen the pressure off the fusing belt". So you could literally use a couple keys or something that fit in the slots. I found some metal angle brackets that fit perfectly in there. Something like this... https://image.shutterstock.com/z/stock-vector-metal-angle-brackets-and-screws-ironmongery-vector-illustration-560791036.jpg

Synthohol
06-02-2017, 04:59 AM
i never used the jigs, i would just push down and pop the bearings on.
didnt even know what those funny "L's" were screwed to the front til 5 or 6 years after i was working on them.

Custom Search