PDA

View Full Version : KM 8050 dumping K developer material


Custom Search


laserman06
08-19-2008, 11:13 PM
About 6 weeks ago, took a call on a 8050 for voids. Went to the machine and found that the K developer unit was shot. Replaced with a new unit. Checked to make sure that charge wire was installed properly, it was. Ran adjustments, looked great.

About a week and a half ago, another tech took a call for the same reason. Again K developer material was gone. So not realizing that I had replaced the whole unit, he replaced it again.

The customer just called it in again for the same problem. Any ideas what could cause this? Driving me crazy!!!:mad:

random
08-20-2008, 08:09 AM
well the only way a dev tank can empty is via the drum unit. This would only happen if there was a massive discharge in the drum due to a crappy charge unit. I would atleast check the drums, cc and bias.

Custom Search