Konica Minolta 1050E with SC36-06, changed TH3 and TS2 can't get rid of code

[Eleshuvio]

Replaced TH3 and TS2, Turn on service mode and it shows 3-0 not 3-1, doesn't matter what I change it to it still throws the code. Kida stuck at this point, any help would be appreciated.


Thank you,


Dave

[tulintron]

Replaced TH3 and TS2, Turn on service mode and it shows 3-0 not 3-1, doesn't matter what I change it to it still throws the code. Kida stuck at this point, any help would be appreciated.


Thank you,


DaveCheck the I / O check if the thermistors are measuring correctly.Make sure the heat sinks are open.
Check switch DIPSW 03-1 = off
Check behind the ACDB, electrical components that cause fuser error codes.

[mircea]

Replaced TH3 and TS2, Turn on service mode and it shows 3-0 not 3-1, doesn't matter what I change it to it still throws the code. Kida stuck at this point, any help would be appreciated.


Thank you,


Dave

Check fuser back conector for any dmg. Also there might be a fuse blown on your acdb or prcb. You can check all fuses for continuity with a mutimeter. Those fuses are noted with ICP on the board.

Best of luck

[allan]

I had i similar problem on a B1250. Could not get it to work until i changed the funny looking one from a B601.