PDA

View Full Version : Jamming FS-534 finisher


Custom Search


Qball
10-27-2017, 12:57 AM
I have this FS-534 finisher attached to a C754e. It appears that the alignment arms are worn and need to be replaced. I looked all over the service manual and for the life of me can’t find a procedure for replacing these arms. I have the mainframe manual and went looking for a finisher service manual on the Konica site under one stop service but crapped out. Does such a procedure exist? I ant to strangle the asshole who designed this finisher.

Heres a vid of how my prints are exiting


https://youtu.be/-I5A_YNp-mg

antone
10-27-2017, 02:08 AM
I have this FS-534 finisher attached to a C754e. It appears that the alignment arms are worn and need to be replaced. I looked all over the service manual and for the life of me can’t find a procedure for replacing these arms. I have the mainframe manual and went looking for a finisher service manual on the Konica site under one stop service but crapped out. Does such a procedure exist? I ant to strangle the asshole who designed this finisher.

Heres a vid of how my prints are exiting


https://youtu.be/-I5A_YNp-mgLook for Konica Minolta field Bulletin..looks like paper cuts arms

Sent from my SM-N920V using Tapatalk

blackcat4866
10-27-2017, 02:18 AM
FS-534 alignment plate wearing. (http://www.copytechnet.com/forums/konica-minolta/104455-fs-534-alignment-plate-wearing.html)
How about this?: =^..^=

BR549
10-27-2017, 02:20 AM
The second time I had this problem on the same machine I decided instead of replacing the alignment plates again I would adjust the mechanical centering on all trays to the rear a few millimeters then use centering in service mode to realign image on paper. This way the paper doesn't line up on the edge of the plate. That was 2 years ago and I have had no more problems with that since.

Qball
10-27-2017, 03:22 AM
FS-534 alignment plate wearing. (http://www.copytechnet.com/forums/konica-minolta/104455-fs-534-alignment-plate-wearing.html)
How about this?: =^..^=

Dude, that’s killer. Thank you!

Custom Search