View Full Version : Jamming bizhub 185 paper jan in exit section.
paper jam in exit sensor.
the actuator is remaining on after the paper pass.
there is no part number for the actuator.there is part number only for the FUSING & PAPER EXIT SECTION.
any idea?
Toxic
03-30-2018, 09:39 AM
Remove exit section without removing fusing unit,watch to not lose fingers when removing.
Remove actuator and spring,clean actuator and make one more turn with spring so make it stronger so it have more power to return actuator to home position.
remove exit section without removing fusing unit,watch to not lose fingers when removing.
Remove actuator and spring,clean actuator and make one more turn with spring so make it stronger so it have more power to return actuator to home position.
i try this and i solve the problem.
Thank you very much.
Toxic
03-30-2018, 10:40 AM
Recently have same problem and figure out what to try and it works.
Glad to help you.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.