PDA

View Full Version : FS-534


Custom Search


copier addict
05-28-2018, 04:35 PM
Hey everyone
This may have been asked before, but I tried a search and found nothing.
I connected a C284e FS-534 finisher to a C308. I updated the firmware and the FS-534 shows it correctly in service mode.
The question I have is, are there any issues I should be concerned about?
I have run about 200 punched and stapled sets though it without any problems, so am I in the clear?
Thanks for any responses.

rrrohan
05-29-2018, 07:38 AM
Hey everyone
This may have been asked before, but I tried a search and found nothing.
I connected a C284e FS-534 finisher to a C308. I updated the firmware and the FS-534 shows it correctly in service mode.
The question I have is, are there any issues I should be concerned about?
I have run about 200 punched and stapled sets though it without any problems, so am I in the clear?
Thanks for any responses.

Why would you it supports that finisher

B0265
05-29-2018, 09:05 AM
There is some small differences between the "old" and "new" versions of the FS-534 but in our experience it works fine to use the old on a C308.

copier addict
05-29-2018, 11:19 AM
There is some small differences between the "old" and "new" versions of the FS-534 but in our experience it works fine to use the old on a C308.

Thanks.

Custom Search