tech51
07-11-2018, 05:21 PM
I have a c3350 where the long edge alignment (top to bottom) has gone out by about 15mm. I can adjust it back in service mode for single sided copying (glass & df) but for 2 to 2 through the df it’s still a long way out and can’t be corrected.
Has as anyone seen this before?
I’m going back tomorrow with a scanner, df & mfp board.
Your thoughts would be appreciated...
Has as anyone seen this before?
I’m going back tomorrow with a scanner, df & mfp board.
Your thoughts would be appreciated...