View Full Version : Konica c35 says calibrating won't copy
I have a Konica c35 that says calibrating all that time and won't allow you to copy. I have clean the lamp and it looks fairly bright to me. I did reset the transfer belt unit approximately two weeks ago without replacing it. I'm not sure whether I should get a new lamp or a new transfer belt for this machine to take care of the problem any ideas
Phil B.
12-17-2018, 05:46 PM
I have a Konica c35 that says calibrating all that time and won't allow you to copy. I have clean the lamp and it looks fairly bright to me. I did reset the transfer belt unit approximately two weeks ago without replacing it. I'm not sure whether I should get a new lamp or a new transfer belt for this machine to take care of the problem any ideas
does it display any errors?
more than likely it is the sensors in/around the iTB unit causing the problem...
get the manual ..it should be covered in there
allan
12-17-2018, 06:29 PM
If the ITU is past due change it also clean the sensors. If there are any near empty toners replace them.
Check if the machine keeps the time after a restart.
Hate these machines had a couple do the same thing.
3ktlc
12-17-2018, 07:49 PM
Start with the transfer belt. Clean the sensors.
copyman
12-17-2018, 10:25 PM
I've had that many times when toners are low / empty.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.