Sam Tofu
02-05-2019, 09:25 PM
Mainly work on Sharp, Ricoh and Kyocera. Have manual for this but not finding adjust/calibra for issue.
Issue: On platen glass copy is correct density. Print Engine density correct. However, when scanning the copy is about 3 stops lighter. Glass is clean etc. Only seeing adj for trail lead, magnification etc. not seeing anything re density.
TIA! ;)
Issue: On platen glass copy is correct density. Print Engine density correct. However, when scanning the copy is about 3 stops lighter. Glass is clean etc. Only seeing adj for trail lead, magnification etc. not seeing anything re density.
TIA! ;)