View Full Version : Kyocera guy here with a Minolta question
Scott
06-11-2019, 10:07 PM
I have a C452 needing a transfer belt 1st does anyone have one for sale??? 2nd would a 654e work?? "asking for a friend" LOL
djs9164
06-11-2019, 10:08 PM
Need the specific belt. Usually available through Precision/ Etc.
Sent from my XT1635-01 using Tapatalk
djs9164
06-11-2019, 10:11 PM
Need the specific belt. Usually available through Precision/ Etc.
Sent from my XT1635-01 using TapatalkMy bad. Just checked prcesion roller. Expensive, but same belt.
Sent from my XT1635-01 using Tapatalk
Scott
06-11-2019, 10:11 PM
Is it a tuffy to install the belt on the assembly??
djs9164
06-11-2019, 10:12 PM
Only comes as an assembly . Wouldn't even try to trace the belt.
Sent from my XT1635-01 using Tapatalk
Scott
06-11-2019, 10:26 PM
Ya that is what I am seeing only buy as a assembly, however I am seeing belt for the assembly for sale and not sure I was wanting to tackle that
Synthohol
06-12-2019, 12:07 AM
not worth rebuilding, too easy to ding the belt or crack it.
they are good for 600k+ you will make it back on clicks.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.