PDA

View Full Version : bizhub C10 scan to email set up


Custom Search


Brett GS
10-15-2008, 01:28 PM
Hi all.
Could some one please guide me through the setting up of a bizhub c10 scan to email,i havent had to do it until now and not 100% sure of where to start.:confused:

Regards
Brett

JSC
10-15-2008, 09:00 PM
Log on to the web interface using the password:-MagiMFP.
Click on the yellow network tab, then on the left hand side select Email.
Make sure 'send' in enabled, enter a sender name, enter an Email address ( this is what will appear in the inbox as the sender )., enter a default subject, enter the smtp server address. click apply and give it a go.

PS you may or may not have to enter authentication info most don't it depends on the system the customer is running.

Good luck

Brett GS
10-16-2008, 08:32 AM
Log on to the web interface using the password:-MagiMFP.
Click on the yellow network tab, then on the left hand side select Email.
Make sure 'send' in enabled, enter a sender name, enter an Email address ( this is what will appear in the inbox as the sender )., enter a default subject, enter the smtp server address. click apply and give it a go.

PS you may or may not have to enter authentication info most don't it depends on the system the customer is running.

Good luck


Will give it a go,thakns for the help,much appreciated.

Custom Search