PDA

View Full Version : CQ Pansonic DPC 405

Custom Search


denden4h
09-26-2019, 02:42 PM
I recently replaced the Transfer belt for a customer and they keep getting a message for some auto adjustment that takes about 15 minutes before it prints anything. I have reset everything I can think of to clear this error. I wanted to try firmware, but can't find it. If anyone has the firmware or a solution to my dilemma, it would be appreciated.
Phil B.
09-26-2019, 03:17 PM
I recently replaced the Transfer belt for a customer and they keep getting a message for some auto adjustment that takes about 15 minutes before it prints anything. I have reset everything I can think of to clear this error. I wanted to try firmware, but can't find it. If anyone has the firmware or a solution to my dilemma, it would be appreciated.

you have to run the AUTO adjust after replacing the belt and might have to run registration adjust also

Custom Search