Juxta5
10-18-2008, 01:34 AM
I just changed out only the Black Developer on a KM 8050, because it's page count was twice that of the CMY...
As usual, I did an "Automatic developer charge for K" only in Mode 36
No problems there
Then, I went to do the "L-detect initial auto adj K, Conduct K only"
Pressed Start and the screen says Error. :confused: tried it again, still says error.
I checked the Density Sensor's connection and it is tight.
So now, I am thinking of replacing the Toner Density Sensor on the K Developing Unit. But was wondering if anyone has a different suggestions before I do. This machine is NOT throwing any Service Codes.
What a stinkin' way to end my Friday, I'm going out for a beer.
As usual, I did an "Automatic developer charge for K" only in Mode 36
No problems there
Then, I went to do the "L-detect initial auto adj K, Conduct K only"
Pressed Start and the screen says Error. :confused: tried it again, still says error.
I checked the Density Sensor's connection and it is tight.
So now, I am thinking of replacing the Toner Density Sensor on the K Developing Unit. But was wondering if anyone has a different suggestions before I do. This machine is NOT throwing any Service Codes.
What a stinkin' way to end my Friday, I'm going out for a beer.