View Full Version : BH-C-3110, CE Password
Hansoon
10-13-2019, 01:31 PM
Got from a wholesaler a BH-C-3110 with only 5k on the clock. CE Password has been changed to unknown. The usual 927...... is not accepted. Cannot call up the service mode.
Any solution please?
Hans
blackcat4866
10-13-2019, 02:39 PM
I'm willing to take a gamble that the password is not changed, it's just a little more difficult to identify. I spent a good hour figuring this out. It's only a slight variation on the Konica Minolta standard:
V x8 down arrow to Utility > Select > Stop 00 Stop 01 > * to change alpha to numeric > 92729272 >
Select
Are you doing firmware? It's a little strange compared to the usual Konica Minolta way. I'll attach the document:
=^..^=
Hansoon
10-13-2019, 05:26 PM
Thanks Cat. Yes, I am aware of that Alphanumeric issue and took care of it from the beginning, but no way.
Hans
allan
10-13-2019, 06:22 PM
Whats wrong with it? O forgot its a toner chewing faulty thing.
Hansoon
10-14-2019, 07:54 AM
Whats wrong with it? O forgot its a toner chewing faulty thing.
Its not accepting a new K-Toner cartridge. Did all the usual, terminals, harness etc.
Hans
tsbservice
10-14-2019, 06:21 PM
You can try Engine DIPSW 28, that will execute forcibly new release of a toner cartridge...in case toner chip is bad.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.