View Full Version : Konica Minolta c203
Anthony mazimum
10-16-2019, 10:44 PM
My konica Minolta c203 complains of replacing the transfer belt unit, I replaced the sensor and the transfer belt but the problem still persists. But the transfer belt works in another machine.
Urgent answers needed please. Thanks
Woxner
10-17-2019, 12:35 AM
replcace the fuse on the belt and reinstall. it works on another machine because the counter is different from the other belt . if fuse wont blow check icp on the board. also you must use the proper rated fuse. if you have the proper firmware you can set this to no stop
Anthony mazimum
10-17-2019, 06:23 AM
Plz where is the icp located on the board & how can I set it to no stop. If possible describe with images.
Thank you!
copyman
10-17-2019, 01:20 PM
Plz where is the icp located on the board & how can I set it to no stop. If possible describe with images.
Thank you!
Make small donation to this site and request service manual. No way to explain with pictures, etc.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.