View Full Version : CQ Ineo+ 3350 low density
DonPedro
10-23-2019, 08:29 AM
Hi. I have problem with density after a few printouts. When I open and close side door everything is ok for short period. Can't enter service mode because CE pass is changed. Previous service probably changed CE.
Any suggestion?
Thanks for help
tsbservice
10-23-2019, 09:31 AM
Did you clean PH windows with cleaning tool? Those can be buried with toner.
Hi, I suggest you share more information like the counter, consumables status, demo page ...
allan
10-23-2019, 11:34 AM
So the transfer roller looses pressure or electrical contact?
mo0651
10-23-2019, 02:20 PM
We did have one machine that the door ground contacts were causing this intermittent issue.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.