View Full Version : CQ Biz Hub 658e
antone
10-23-2019, 11:29 PM
Brand new out the box!All trays paper goes up to fuser and folds up! Checked senors and run motors and they are good ! Any help would B nice!
Sent from my SM-N950U using Tapatalk
blackcat4866
10-23-2019, 11:57 PM
So does it jam? What jam code?
Does it error out? What error?
I think we'll need just a little more than that. =^..^=
Woxner
10-24-2019, 03:23 AM
did you run the fuser drive motor and clutch. bad clutch will do this. had a new c458 do this. also there is a bd just above the mfp on the right called excb that could be bad
mo0651
10-24-2019, 10:33 PM
On the door that swings open, there is a push arm that goes thru the frame of copier on rear side just below the fuser. This arm pushes on a spring loaded lever behind frame.
We have had a couple of machines where that lever was broken and/or popped out of place. causing this issue. Worth a look. It is part of the fuser drive pack.
antone
10-25-2019, 03:22 AM
Is there a way to see the lever..at all?
Sent from my SM-N950U using Tapatalk
mo0651
10-25-2019, 01:59 PM
You have to get the door open all the way and look in little square hole. Take a pen and see if that lever inside works. Oh yeah you have to bend down and look in!:cool:
antone
10-30-2019, 01:10 AM
Found it works fine!Any thing else to look for. help!
Sent from my SM-N950U using Tapatalk
rrrohan
10-30-2019, 01:41 AM
still waiting on jam codes
antone
11-06-2019, 11:44 PM
Jam code 3003
Sent from my SM-N950U using Tapatalk
rrrohan
11-07-2019, 01:06 AM
Jam code 3003
Sent from my SM-N950U using Tapatalk
43959
blackcat4866
11-07-2019, 01:33 AM
My vote is for CL8 or PS3. In one case both. =^..^=
allan
11-07-2019, 04:43 AM
Does the sensor flag above the transfer roller pop back freely or plugged in?
But i think that would be J2002.
antone
11-07-2019, 11:57 PM
change the complete fuser drive unit today...no change! help
Sent from my SM-N950U using Tapatalk
antone
11-08-2019, 12:02 AM
also complete fuser!!
Sent from my SM-N950U using Tapatalk
antone
11-08-2019, 02:29 AM
did you run the fuser drive motor and clutch. bad clutch will do this. had a new c458 do this. also there is a bd just above the mfp on the right called excb that could be badchange that 2
Sent from my SM-N950U using Tapatalk
blackcat4866
11-08-2019, 02:20 PM
... and PS3? =^..^=
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.