View Full Version : Konica Minolta bizhub 754e C3101 !
rvptor
01-29-2020, 04:09 PM
This is the machine above. I changed the main board, fuser, rear arm, transfer belt, it still throws out the same code. A colleague tried to reset the machine to the factory ones but that didn't solve the problem either ..... If anyone has met before, thanks in advance: D
This is the machine above. I changed the main board, fuser, rear arm, transfer belt, it still throws out the same code. A colleague tried to reset the machine to the factory ones but that didn't solve the problem either ..... If anyone has met before, thanks in advance: D
Try the fusing roller separation motor and/or relative parts?
CompyTech
01-29-2020, 06:26 PM
There's a plastic bushing that sits on the drive shaft of the M29 that cracks. Design was changed to a brass bushing. Might be better off replacing the fuser drive assy.
rvptor
01-29-2020, 07:56 PM
There's a plastic bushing that sits on the drive shaft of the M29 that cracks. Design was changed to a brass bushing. Might be better off replacing the fuser drive assy.
Thanks for your response...I forgot to mention that i already implement fuser drive assembly as well...
44763
Hello, the manual also indicates the replacement of the PRCB
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.