Konica C754e CE Mode Imaging Process Adjustment PRINTER FEET have values

[denvertan]

These C754e is very different from the normal Konica Machine I see before.
It have value at PRINTER "FEET" at CE Mode Imaging Processing Adjustment.

I have try to run Stabilizer + Initialize Data
Then redo the Imaging Processing Adjustment again.

But the FEET still have value.
Up to my knowledge PRINT FEET value should be ZERO only Copy can have values other than zero.

May I have your guidance to fix this ? I have been going through the service manual but only mentioning is zero, if not zero rerun.
But I have attempted like 10 reruns. :mad::mad:

45015

[Bix]

You can't have a value of 0. The value of 0 is perfection and you don't have it with a new MFP either. Temporarily get the value zero when doing the initialization but it is only a fantasy value. The tolerated value is from +/- 100

[allan]

These C754e is very different from the normal Konica Machine I see before.
It have value at PRINTER "FEET" at CE Mode Imaging Processing Adjustment.

I have try to run Stabilizer + Initialize Data
Then redo the Imaging Processing Adjustment again.

But the FEET still have value.
Up to my knowledge PRINT FEET value should be ZERO only Copy can have values other than zero.

May I have your guidance to fix this ? I have been going through the service manual but only mentioning is zero, if not zero rerun.
But I have attempted like 10 reruns. :mad::mad:

45015

So what is wrong with the machine?
If it ain't broken don't fix it...

[tsbservice]

But the FEET still have value.
Up to my knowledge PRINT FEET value should be ZERO only Copy can have values other than zero.

45015


Conv. Values should fall within ±100 for Dark Values and ±60 for Highlights. The closer the values are to 0, the better the results.

1. The “FEET” values are just for reporting and are not used to determine if they are within acceptable limits.
2. The “Printer Resolution” Conv. Values are the ones which should be used to determine if the MFP is operating within target values.

Rethink about your knowledge, seems you've missing very basic steps.