View Full Version : Konica minolta fiery e300-09 ic-418
karel
04-07-2020, 07:15 PM
Hi guys
i need the system software and inctructions for fiery IC-418/E300-09
For model KONICA MINOLTA C759
Thx.
Phil B.
04-07-2020, 07:49 PM
Hi guys
i need the system software and inctructions for fiery IC-418/E300-09
For model KONICA MINOLTA C759
Thx.
what issues are you having?
karel
04-07-2020, 07:59 PM
what issues are you having?
I bought a used controller without a hard disk
emujo2
04-07-2020, 08:02 PM
Are you aware that the 418 software is a 4gb ISO? Are you a KM direct/dealer?
karel
04-07-2020, 08:08 PM
Are you aware that the 418 software is a 4gb ISO? Are you a KM direct/dealer?
I know it's about 4GB, I'm not a dealer
Synthohol
04-07-2020, 09:28 PM
PM sent, thanks for being a contributor!!
karel
04-07-2020, 10:32 PM
PM sent, thanks for being a contributor!!
Synthohol Thank you so much
karel
04-11-2020, 09:08 AM
Synthohol Thank you so much
Hi guys,
I uploaded to a USB flash drive using USB Setup Tool System Software +
User Software - the pendrive is ready!
I installed a new clean 500GB disk in IC-418
Can anyone give me a hint how to carry out the next stage?
Synthohol
04-11-2020, 04:11 PM
i did the pen drive install once, i hated it.
i install via ethernet and my laptop so i can see the progress.
do you want the service manual?
PM sent, it was too big to attach here.
karel
04-13-2020, 10:32 AM
i did the pen drive install once, i hated it.
i install via ethernet and my laptop so i can see the progress.
do you want the service manual?
PM sent, it was too big to attach here.
Installation of the system software using a USB flash drive was successful.
Synthohol once again many thanks for the software system and technical documentation
Synthohol
04-13-2020, 02:37 PM
thanks again for being a contributor.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.