View Full Version : Anyone familiar with the BH 25e ?
EarthKmTech
05-07-2020, 12:21 AM
I've never seen them anywhere before except a customer I have on a remote island with 5 of them I cant even get to for obvious reasons.
The issue is it keeps saying the side door is open (the main side door)
I dont even remember how the door is detected as closed, is there a switch a photo sensor or what? Is there a tab that snaps off the door, anything like that?
The parts manual for this machine has disapeared like its never existed too.
patrickjlc
05-07-2020, 12:32 AM
Is it like this?https://uploads.tapatalk-cdn.com/20200506/f043ff8eabb12a464732919abd2b79d6.jpghttps://uploads.tapatalk-cdn.com/20200506/3f8452f41fd87e3c9c97655fab0ad71b.jpg
Sent from my SM-G930V using Tapatalk
copyman
05-07-2020, 12:52 AM
Just looked at your picture again. That is the Biz 25 NON "E". I think this was a Kon/Min made box and wasn't that good. The 25 "E" covers are black and is made by Muratec. It is a decent small box. Sorry don't know the type of sensor used for side door but if you PM me your email I will send you parts manual for Biz 25 which should show what is used.
EarthKmTech
05-07-2020, 12:52 AM
45608
I'm not sure about that one, this is the one we sold - They were never sold in all markets and KM themselves left it up to each region to decide if they wanted to sell them. They are a Muratec engine.
tsbservice
05-07-2020, 10:16 AM
I've never seen them anywhere before except a customer I have on a remote island with 5 of them I cant even get to for obvious reasons.
The issue is it keeps saying the side door is open (the main side door)
I dont even remember how the door is detected as closed, is there a switch a photo sensor or what? Is there a tab that snaps off the door, anything like that?
The parts manual for this machine has disapeared like its never existed too.
Send me PM and I will upload Parts Manual/Service Manual and give you the link.
srvctec
05-07-2020, 04:33 PM
Maybe the side door interlock actuator is broken off or the accompanying sensor is bad?
https://uploads.tapatalk-cdn.com/20200507/1593c453c8124f627e8c577f73c646da.jpg
EarthKmTech
05-08-2020, 01:04 AM
Just a closure to this thread - I ended up finding the muratec parts manual, found the door interlock - showed the customer in email.
They glued a fin extension onto the door itself and the machine is operational again.
Gotta love customers that can fix things themselves.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.