View Full Version : 360i drum error
Genotrom
06-25-2020, 08:13 AM
yesterday I installed the new bizhub 360i (black and white only). Today the customer who called "Drum detection error" came out on the display. Being just black and white, I can't try other drums. Any suggestions? It only has 200 on the counter.
tsbservice
06-25-2020, 08:24 AM
It happened to me once on C250i. Exchanged M and Y drums and message went away for now. Same scenario almost brand new machine.
Genotrom
06-25-2020, 09:36 AM
It happened to me once on C250i. Exchanged M and Y drums and message went away for now. Same scenario almost brand new machine.
thanks, I would like to do it, but as I said, this is not a color printer. This is a black and white printer (without the C in front)
Interestingly, I didn't know about the new black and white printers. However I believe that condensate may have arisen. Leave it out for a couple of minutes (remember to protect the surface) and then reinsert it.
fatduke
06-25-2020, 01:09 PM
yesterday I installed the new bizhub 360i (black and white only). Today the customer who called "Drum detection error" came out on the display. Being just black and white, I can't try other drums. Any suggestions? It only has 200 on the counter.
Interesting man.
Maybe you forget to remove any protection? A little piece of plastic tape somewhere?
Also check deep in the drum location inside if there is something dirty.
Can you please attach a sample? TY
ivovb
06-25-2020, 09:02 PM
Check/clean/set contacts concerning drum chip and HV contacts, too.
BR
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.