PDA

View Full Version : Scanner problem squares Bizhub C203


Custom Search


furius
09-01-2020, 09:56 AM
Hi guys, I have this problem on a C203 that has the mfpb replaced.
I have already tried machine initialization and entered the scanner serial!
Do you have any suggestions?

20200901-101318 — ImgBB (https://ibb.co/wRJLQRm)

Toxic
09-01-2020, 10:59 AM
You should do full complete installation procedure from scratch.

Synaux
09-02-2020, 05:04 AM
Hi guys, I have this problem on a C203 that has the mfpb replaced.
I have already tried machine initialization and entered the scanner serial!
Do you have any suggestions?

20200901-101318 — ImgBB (https://ibb.co/wRJLQRm)

DING DING DING SHAME SHAME - YouTube (https://www.youtube.com/watch?v=SrDSqODtEFM)
:rolleyes:

furius
09-02-2020, 02:53 PM
You should do full complete installation procedure from scratch.
Have already performed the machine installation procedure as per manual, but unfortunately without results :confused:

bsm2
09-02-2020, 04:03 PM
run it again

Toxic
09-02-2020, 04:28 PM
run it again
...and follow procedure blindly,do not skip any step.
Long ago one of my coleague (rookie in that time) ask senior technician why some steps in install or service manual is not logical in some cases.
He got answer, if in manual says "run 3 circles arround machine", do it or you can have troubles later. :)

Phil B.
09-02-2020, 04:52 PM
...and follow procedure blindly,do not skip any step.
Long ago one of my coleague (rookie in that time) ask senior technician why some steps in install or service manual is not logical in some cases.
He got answer, if in manual says "run 3 circles arround machine", do it or you can have troubles later. :)

damn rookies... I had one decide which screws weren't needed.. he only put 2 of the 4 screws back on a main drive motor.. back in the days of chain driven analogs

didn't fair well for him at all :cool:

furius
09-03-2020, 09:18 AM
...and follow procedure blindly,do not skip any step.
Long ago one of my coleague (rookie in that time) ask senior technician why some steps in install or service manual is not logical in some cases.
He got answer, if in manual says "run 3 circles arround machine", do it or you can have troubles later. :)

I'll try running the whole installation process again and let you know
Thank you guys

Synaux
09-04-2020, 04:31 AM
I'll try running the whole installation process again and let you know
Thank you guys
Double check:

Date and time enter in one location
Touch panel not adjusted

(I bet the person(s) responsible for this gets a wet spot in their pants every time someone forgets to do one little thing in this procedure. Perhaps there is valid reason for this, but I feel like this is just a troll-maneuver.)

Custom Search