View Full Version : i series reset tools
Hi everybody
I wanna ask KM provide reset tools for i series?
Best regards,
tsbservice
10-16-2020, 06:03 AM
Are you solving specific problem or just in case?
Are you solving specific problem or just in case?
HI tsbservice,
One C250i has issue that boot up only 25%, later on I will take CPUB and SSDB for testing.
I consider when CPUB is not relative with this case, I can initialize it with this tools like the procedure on previous 4e series.
Change the STRB and update the firmware to G00- B6
Thank you Bix.
Since I tried the following :
- Enter the tech Rep mode by reset key + main SW on
- Enter the load FW mode by stop key + main SW ON
They all display 25% boot up screen with black dot only, so I'm not sure the condition of CPUB is ok or not.
copier tech
10-20-2020, 09:16 PM
Thank you Bix.
Since I tried the following :
- Enter the tech Rep mode by reset key + main SW on
- Enter the load FW mode by stop key + main SW ON
They all display 25% boot up screen with black dot only, so I'm not sure the condition of CPUB is ok or not.
With the iseries you use the small button behind the control panel to load firmware.
Woxner
10-20-2020, 10:09 PM
one way to test storage board is to remove it and see if it will load firmware. it wont load controller though
Woxner
10-20-2020, 10:10 PM
and the 8 series reset tool is used for i series as well
With the iseries you use the small button behind the control panel to load firmware.
Yup, I really use this way attempt to load the B6 firmware.
However, it stay on 25% boot up screen with up left corner dot only.
and the 8 series reset tool is used for i series as well
I don't have this tool :(
one way to test storage board is to remove it and see if it will load firmware. it wont load controller though
Thank you your advise, I tried this day however it stay same. ( 25% boot up screen with black dot )
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.