datapresstecnica
11-19-2008, 02:10 PM
I have a Di7210 with it's pi7200e controller. When you send a large print job (anithing over 350 pages) through both PCL or PS drivers the controller starts ripping normally but it doesn't stop when the copier's ram is full. As a result, the controller displays the message of memory overflow, but the machine doesn't report any error. It just prints the job with the pages that fit in the ram and then discards the job as if it had been completed normally. I've been trying to find any sort of option in the fiery's setup or the copier to prevent this error but i've only found a sw switch in the copier to delay the comunication with the controller. Obviously it didn't make any significant difference.
Since everything else seems to be working fine and I didn't have any other trouble printing, I'd like to know if this is a malfunction on either copier or fiery or if there's any way to solve this problem through configuration changes.
Thank's a lot.
Since everything else seems to be working fine and I didn't have any other trouble printing, I'd like to know if this is a malfunction on either copier or fiery or if there's any way to solve this problem through configuration changes.
Thank's a lot.