PDA

View Full Version : Error Code C300i , code C 9401


Custom Search


pinspin
02-26-2021, 07:32 AM
Hello. When turned on, the lamp lights up, the scanner starts moving and the copier shows the code C 9401. We replaced Led exposure unit, CCD unit, SCDB, CPUB, Baseb,power supply, flat cable, storage and performed a firmware update. It did not help. We would be grateful for any advice! Thank.

tsbservice
02-26-2021, 08:04 AM
Holy c.ap! You replaced more than all required and it still won't work. Any options added, try without them.

Bix
02-26-2021, 08:28 AM
48440


Anyof the trouble codes C6102/6751/9401. Itis caused by the loose screw at the timing belt pulley.Ifthe screw was loosened, the pulley is idling which makes scanfunction faultily.Asthe result, the trouble codes related to the scan malfunction occurfrequently.

Tightenthe screw if it is loosened.
Ifthe screw is not loosened, it must be caused by other causes. Pleasecheck the tension of the belt or check other solutions on the servicemanual.

pinspin
02-27-2021, 01:03 PM
We performed all the recommendations, the problem is not solved. Thanks for the advices, we continue to diagnose)))

dawidos01111
03-26-2024, 08:10 PM
We performed all the recommendations, the problem is not solved. Thanks for the advices, we continue to diagnose)))
What is the solution to the problem?

allan
03-26-2024, 08:15 PM
What is the solution to the problem?


Have you check the small timing belt on the motor for damage?

dawidos01111
03-26-2024, 08:35 PM
Have you check the small timing belt on the motor for damage?

Yes, he's correct. I have a problem with this error on C450i. I replaced LED Exposure unit, scdb, ccd unit, cpub and baseb. FW G00-P8 and GC2-Q9. I replaced wiring between scdb and led exposure unit and ccd unit and baseb. Problem not solved.

occus
03-27-2024, 09:48 AM
Had a c360i/Dual CIS DF with a lot of 94-01.

Check the if the white cleaning Roller of the DF are clean (both, simplex and duplex) and turn correctly.

3.4.2 CIS control when power is turned ON
1. The LEDs of CIS are turned ON.
2. The cleaning brush is detected at its home position.
3. The cleaning brush is rotated and brought to a stop at the gain adjustment position.
The gain adjustment is made twice with the cleaning brush at that position.
4. After the adjustments, the LEDs are turned OFF.
5. The cleaning brush is rotated and brought to a stop at the home position.
• The same control is performed when the main body exits from the sleep mode

tsbservice
03-27-2024, 07:55 PM
Yes, he's correct. I have a problem with this error on C450i. I replaced LED Exposure unit, scdb, ccd unit, cpub and baseb. FW G00-P8 and GC2-Q9. I replaced wiring between scdb and led exposure unit and ccd unit and baseb. Problem not solved.

I would unset and disconnect DF and try machine again.

Custom Search