PDA

View Full Version : IC-417 boot errors, non functioning web UI, updates fail


Custom Search


Faravid
04-27-2021, 01:49 PM
Hi,

Konica Monilta C2070 and Fiery E300-04 IC-417.

I managed to reinstall system software to IC-417 (replaced a dead HDD), but I'm getting following errors:

Controller boots fine and ends to 00 state as it should.

Printer controller menu only shows following error:
"The request URL could not be retrieved."

If connect I a monitor to monitor port the operating systems says following:
"i2c-algo-ich: ICH_GPIO sendbytes: error - bailout
kvf_driver_init: registered 18 device numbers
i2c-algo-ich: ICH_GPIO sendbytes: error - bailout"

I am able to connect ti IC-417 with Fiery Command Workstation, but I cannot access configuration because of non functioning web UI.

Command Workstation reports updates available but I cannot install them because timeout to update server.

tulintron
04-27-2021, 01:59 PM
Hi,

Konica Monilta C2070 and Fiery E300-04 IC-417.

I managed to reinstall system software to IC-417 (replaced a dead HDD), but I'm getting following errors:

Controller boots fine and ends to 00 state as it should.

Printer controller menu only shows following error:
"The request URL could not be retrieved."

If connect I a monitor to monitor port the operating systems says following:
"i2c-algo-ich: ICH_GPIO sendbytes: error - bailout
kvf_driver_init: registered 18 device numbers
i2c-algo-ich: ICH_GPIO sendbytes: error - bailout"

I am able to connect ti IC-417 with Fiery Command Workstation, but I cannot access configuration because of non functioning web UI.

Command Workstation reports updates available but I cannot install them because timeout to update server.You can try to remotely access the IC desktop via Windows using the shortcut command MSTSC.

tulintron
04-27-2021, 02:13 PM
These errors are from Linux and show to be some bad contact on some hardware. Try to remove them all, clean the connections, connect them again and redo the installation of the system software.

Faravid
05-05-2021, 12:41 PM
Thanks, managed to get it working by removing all connectors, RAM, PCI-E expansion card and resetting them.
After that ran a full reinstall.
Now WebGUI works and updates download and install.

However. Server is still saying "Product not enabled".
Any idea why this happens?

Konica C2070 is the printer.

Custom Search