View Full Version : BH 808 finisher jam 72-18
splblazer91
09-01-2021, 08:50 PM
FS-536 finisher. It will run 10-15 pages then jam at the finisher entrance rollers. J code 72-18. It never gets past the entrance rollers when it jams. Anyone seen this?
Synthohol
09-01-2021, 11:19 PM
is it getting hung up on a torn black mylar (#4) in the enterance guide?
splblazer91
09-02-2021, 12:22 AM
Negative. Only about 400k on this one. I did go ahead and remove that mylar though. That thing is useless.
Albonline
09-02-2021, 08:01 PM
FS-536 finisher. It will run 10-15 pages then jam at the finisher entrance rollers. J code 72-18. It never gets past the entrance rollers when it jams. Anyone seen this?
Is the ru unit warped enough yet to separate the conveyance rollers?
splblazer91
09-02-2021, 08:53 PM
Is the ru unit warped enough yet to separate the conveyance rollers?
Havent seen that yet but I did move the finisher to a different machine and it did the same thing.
Update: I replaced all the metal and plastic entrance guides as well as the Finisher board. Ran 1000 pages and it never jammed.
escalante
09-04-2021, 08:14 PM
Good afternoon. I hope the following documentation will help you solve your failure. 50078
Enviado desde mi Infinix X692 mediante Tapatalk
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.