View Full Version : km 6501 fusing toner problem
malamat
09-06-2021, 09:34 PM
I'm printing on the machine. Some prints do not fully heat the toner. It does this in between printing. I think the heat rollers do not press sometimes. Or there is a timing problem. Do you have any suggestions for this?thx
lartis.aineias
09-06-2021, 09:39 PM
Classic c6500 and C6000 problem,
especially when it has a lot of black on it!
Clean up an down thermistors,increase the temperature!
you can do nothing more
Στάλθηκε από το AC2003 μου χρησιμοποιώντας Tapatalk
malamat
09-06-2021, 09:50 PM
Klasik c6500 ve C6000 sorunu,
özellikle üzerinde çok fazla siyah olduğunda!
Aşağı termistörleri temizleyin, sıcaklığı artırın!
daha fazlasını
yapamazsın Στάλθηκε από το AC2003 μου χρησιμοποιώντας Tapatalk
my problem is not under heating problem. It doesn't heat at all. For example, I make 10 prints, no problem. But then the paper comes out without pressing the rollers. Then I stop the printing and start again. Sometimes it has problems on the first print.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.