View Full Version : bizhub C4050i Won't update firmware
copyguy69
11-22-2021, 09:24 PM
I have the files on the flash drive correctly and following the instructions, but the machine won't load the files. The machine can see the files so I know the drive and port are working. I did turn off the security settings to allow the firmware to be loaded. Am I missing something? Any suggestions are welcome. Thanks in advance
copyguy69
Synthohol
11-22-2021, 09:48 PM
This may sound silly but you are holding
Down the yellow button with the red dot while turning on the machine right?
If not, there ya go ;)
And the stick only has the folder FW0000xx on it right?
Drive is 8gb or smaller right?
Sometimes it's just the little things. :)
tsbservice
11-22-2021, 10:02 PM
This may sound silly but you are holding
Down the yellow button with the red dot while turning on the machine right?
If not, there ya go ;)
And the stick only has the folder FW0000xx on it right?
Drive is 8gb or smaller right?
Sometimes it's just the little things. :)
Totally agree, one note... works with 32GB thumb drive without problem on new i-series.
copier tech
11-22-2021, 10:03 PM
I have the files on the flash drive correctly and following the instructions, but the machine won't load the files. The machine can see the files so I know the drive and port are working. I did turn off the security settings to allow the firmware to be loaded. Am I missing something? Any suggestions are welcome. Thanks in advance
copyguy69
As Synthohol said but we have found sometimes it may take a few attempts to accept the FW. Usually a reboot & try again it will work.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.