Hey guys,
So, I've got a machine that went dead (its been a long time since I've seen it, but I'll do my best to describe) and we determined that it was likely the SSD board that failed. If I recall, the machine would just sit at the first one or two towers and never go anywhere else.
Has anyone replaced any of these, and if so, what happens when you replace it? Or what kind of programming might I need to do? (never replaced one before on this model). I have the new board though...
OC
So, I've got a machine that went dead (its been a long time since I've seen it, but I'll do my best to describe) and we determined that it was likely the SSD board that failed. If I recall, the machine would just sit at the first one or two towers and never go anywhere else.
Has anyone replaced any of these, and if so, what happens when you replace it? Or what kind of programming might I need to do? (never replaced one before on this model). I have the new board though...
OC
Comment