C-CC00 and screen blinks after installing GDS-M1 Function Version7 for 4e series.

[FixitYo]

C-CC00 and menu screen short cuts all blink after installing GDS-M1 Function Version7 for 4e series across the board B/W and color boxes. Every 4e series in our warehouse tested and same code appears. Has anyone come across this issue?

Changed function levels
Formatted physical and logical
Tried nursing firmware level up to latest with special instead of going from latest base from 2nd to latest which is super old.
End result was bringing level back to G20 - M1

[B0265]

We have seen this a couple of times, it is probably caused by a bad SSD Board.

[femaster]

Old thread, yes...
Just in case anybody is searching for this issue in the future, see the following thread:

Cause & Solution: Menu Blinking / Flashing and C-CC00 Error in xx4 and xx4e Models (https://www.copytechnet.com/forums/konica-minolta/170537-cause-solution-menu-blinking-flashing-c-cc00-error-xx4-xx4e-models.html)

Hopefully it will help someone else out in the future...