konica minolta doc feeder df 624 mylar question

[brent]

so initially I have been getting quite a few jam code 66-05 which I have learned a ton about today.. so I am in the middle of a situation where my customers
over the years get a jam in the turn over section and they siimply pull the original out as hard as they can.. and it is bending up that mylar and causing problems so I have a few feeders that I have just replaced and cut the mylar to make it work etc.. I used some info here to see how to get into that turn around section out to replace the mylars? huge job I know.. any thoughts on that procedure?

I love this site and thank everyone for helping everyone learn etc. thank you

brent

[Woxner]

I leave the mylars out. works just fine. its one long mylar

[blackcat4866]

I made a new mylar for one. I'm not sure how you're supposed to do it ... but I ended up drilling a hole to access the screw that I could not get out:

5217852179

It was a major operation, even then.

[brent]

thanks guys.. I will see what I can come up with.. I still have these machines in the field they are good for the most part
lo;



brent

[tech51]

I leave the mylars out. works just fine. its one long mylar
I agree. As long as you clean off as much of the glue as possible.
It is possible with a little care to drop it in from the top once the top cover feed section has been removed.