brent
02-18-2022, 08:15 PM
so initially I have been getting quite a few jam code 66-05 which I have learned a ton about today.. so I am in the middle of a situation where my customers
over the years get a jam in the turn over section and they siimply pull the original out as hard as they can.. and it is bending up that mylar and causing problems so I have a few feeders that I have just replaced and cut the mylar to make it work etc.. I used some info here to see how to get into that turn around section out to replace the mylars? huge job I know.. any thoughts on that procedure?
I love this site and thank everyone for helping everyone learn etc. thank you
brent
over the years get a jam in the turn over section and they siimply pull the original out as hard as they can.. and it is bending up that mylar and causing problems so I have a few feeders that I have just replaced and cut the mylar to make it work etc.. I used some info here to see how to get into that turn around section out to replace the mylars? huge job I know.. any thoughts on that procedure?
I love this site and thank everyone for helping everyone learn etc. thank you
brent