MINOLT BIZHUB C360 alignment problem on color prints

[tecnomarco]

hello to all I have a problem on prints and color copies of yellow color alignment .... it creates a double line for me a "line position problem ... in assistance mode how can I correct this, can you tell me the simulation to do? in assistance mode..thank you I have attached some prints

[davidj7]

are you using compatible drums?

did it happen just all of a sudden or after drums were changed?


in service mode ->stabilization should fix it

[tecnomarco]

Thank's David ...yes I use drum compatible but I have change only drum black, not colour..:confused:

[tecnomarco]

they are complete compatible drums not regenerated by me

[tsbservice]

Thank's David ...yes I use drum compatible but I have change only drum black, not colour..:confused:

Color registration is based on K(black) so...
Remove ITB and clean IDC sensors (x2) then as suggested make stabilization.
By the way this compatible drum does it have new chip?

[tecnomarco]

Color registration is based on K(black) so...
Remove ITB and clean IDC sensors (x2) then as suggested make stabilization.
By the way this compatible drum does it have new chip?

Thank's I will do as you say

[occus]

I see a little skew on yellow...
Clean IDC Sensors, go first in machine>print head skew adjustment>print head skew adjustment reset 2x and make the stabilization and gradations adjumstments.

I think it's important to have a black drum in good conditions.

[tecnomarco]

I see a little skew on yellow...
Clean IDC Sensors, go first in machine>print head skew adjustment>print head skew adjustment reset 2x and make the stabilization and gradations adjumstments.

I think it's important to have a black drum in good conditions.

Thank's occus i change the new drum black but can you explain to me this simulation....machine-print head skew adiustment....ecc