time2fly
01-13-2009, 05:04 AM
I'm trying to setup a wireless Access Point on a Di3510 so my customer can print through his wireless network. I've done this before using Linlsys hardware but this time it's Netgear hardware. I've tried every conceivable setting and cannot see it on the router. I know it has a USB port on the copier I didn't at the time the AP was being purchased. Can the AP be used or is a USB print controller be a better choice. The AP is a Netgear WG602v4 and the router is also a Netgear I don't remember the model but it will connect up to 108mbps. Any advice would be helpful.