Konica Minolta 8050 SC34-08 error message

[Arlette]

I have a Konica Minolta 8050 SC34-08 error message on my machine and need to know how to get it turned off.

I also have washed out white areas on the second side of 8.5X11. There is not a problem with 11X17 or 12X18. It does not matter whether it is duplexed or fed in twice.

[liquidtech]

How to clear fuser abnormality codes (F34-xx, F35-xx, F36-xx).
Solution:
To reset a fuser abnormality code, perform the following:
1. Access the 25 mode (hold down the 2 and 5 keys at power up) or turn the main switch ON and wait for the Ready to Copy message. Hold the P button down until the message Enter 4-digit Password To Change is displayed.
Note: The button must be held down for about 5 seconds before the message is displayed.
2. Enter the password 9272 and press the Start Print button.
3. Press [1: Software SW setting] on the touchscreen.
4. Press the left up-arrow, which is displayed on the touchscreen, 2 times. The number displayed above the up-arrow will change to 03.
5. Select the bit number of switch 1, using the right up-arrow, 03-1 will be displayed.
6. Press the [OFF (0)] key, which is displayed on the touchscreen.
7. Power the machine OFF/ON to exit the 25 mode or press RETURN, MODE CHANGE and then BASIC SCREEN to return to normal operation.

[Juxta5]

Error code relating to fuser

If the error code keeps coming back, you should not keep resetting it. You need to find the source of the problem. If one of the temperature sensors in your fuser is defunct (i.e., TH4) then the fuser will overheat.

Can you upload a picture of duplexed 8.5 x 11 that has white spots?