PDA

View Full Version : Jamming Bizhub c224 with DF 624 Doc feeder jam


Custom Search


tekkie
11-08-2022, 04:14 PM
Hi guys help needed
Bizhub c224 with a DF 624.
Its feeding fine but when it gets a jam the jam won't reset and the pick up rollers don't reset back to up position.
The only way to reset the jam is power of and then on.
The jam code is 6602 and 6633.
Once the rollers have reset and jam clear can feed single and double sided all fine.
But if I stop a sheet to bring up a jam by holding it back as if it hasn't picked up then the jam won't clear and the rollers won't reset back up unless i put a doc in feeder with lid up then bring DF down and rollers reset then

femaster
11-08-2022, 07:26 PM
If you open the access door on the RADF when not in a jam state, does the display on the copier indicate that the access door is open? It sounds like the open/close sensor is not functioning so the copier thinks the access door was never opened to clear out the jam. If the door is never detected as being opened, the jam will never clear, and the motor that lifts the feed assembly will never operate to lift it.

tekkie
11-08-2022, 08:51 PM
I am going back on Friday I will check this
Thanks for that

elmaligno
11-09-2022, 08:26 AM
Hi guys help needed
Bizhub c224 with a DF 624.
Its feeding fine but when it gets a jam the jam won't reset and the pick up rollers don't reset back to up position.
The only way to reset the jam is power of and then on.
The jam code is 6602 and 6633.
Once the rollers have reset and jam clear can feed single and double sided all fine.
But if I stop a sheet to bring up a jam by holding it back as if it hasn't picked up then the jam won't clear and the rollers won't reset back up unless i put a doc in feeder with lid up then bring DF down and rollers reset then

Replace the item A3CFPP7000. Trust me.

occus
11-10-2022, 01:15 PM
Replace the item A3CFPP7000. Trust me.
Yes! the white Gear with Clutch.

tekkie
11-14-2022, 09:50 PM
Thanks for the help everyone I see the gear clutch assembly but somehow the 3 pin connector for the Df door open/close sensor had come off the board completely refitted it and it was fine .
Stripped that gear assembly down and cleaned the clutch working a treat now
Cheers Guys

Custom Search