New SSD bizhub C-224e

[CP-1015]

I installed a new SSD in a C224e. In the absence of installation instructions, of course, cyan and magenta lines. Installation instructions are now available. How do I proceed? Have I tried deleting and reinstalling again with reset tool without success? The serial numbers, for example, have remained. Thanks in advance!

[tsbservice]

Do Stop + 3 setup...

[Synthohol]

In the absence of installation instructions,
you are a contributor, just ask for them next time ;)

[Elmo]

55461

[CP-1015]

Do Stop + 3 setup...

I did: Stop - 1 - 1 - 4 - 4 - c. Was it wrong? I thougt Stop + 3 is for 8-series?

[CP-1015]

you are a contributor, just ask for them next time ;)

Ok, netxt time. But how I have to reset before insatll procedere after my foult? I tried with reset tool again, but it wasn't successfull. For excample serial numbers aren't deleted.

[tsbservice]

Did you update firmware after SSDB replacement?
Enter service mode and press stop and 3 to start initial setup of date and time etc.

P.S. As I'm comparatively freshman with KM I never installed brand new 4e series machine so I may be mistaken about initial setup. Just try.

[CP-1015]

Did you update firmware after SSDB replacement?
Enter service mode and press stop and 3 to start initial setup of date and time etc.

P.S. As I'm comparatively freshman with KM I never installed brand new 4e series machine so I may be mistaken about initial setup. Just try.

OK, I'l try it today.

[CP-1015]

Perfect! Thanks everyone! Firmware I datet up for start after SSD replacement.