Juxta5
03-17-2009, 09:09 PM
I have an 8150 that is not putting an image in the same place on a page. When fed from the stack by-pass
For example, if a document is printed where all the crop marks are at 1" -- they print at 1.25", .75", 1.125" etc. they are all over everywhere -- they are not staying consistent for even as low as 3 prints. :mad:
I cleaned & checked feed rollers.
The registration on this machine WAS GOOD 3 days ago, same paper, same file.
Any ideas where else I should look? THANK YOU IN ADVANCE!!!
For example, if a document is printed where all the crop marks are at 1" -- they print at 1.25", .75", 1.125" etc. they are all over everywhere -- they are not staying consistent for even as low as 3 prints. :mad:
I cleaned & checked feed rollers.
The registration on this machine WAS GOOD 3 days ago, same paper, same file.
Any ideas where else I should look? THANK YOU IN ADVANCE!!!