View Full Version : C350 need help code p31
tarzak911
03-26-2009, 01:28 PM
Hi have this code come up when making copies,but not whilst printing..any ideas...
Thank u.
copy guy
03-26-2009, 02:47 PM
PC home sensor (K) malfunction. Perform faulty sensor check. During stabilize mode, phase detect sensor should change values. Clean if needed. Could be transport drive assembly or PRCB.
-----------------------------------------------------------------------
Good luck and may the schwartz be with you.:cool:
B0265
03-27-2009, 08:52 AM
We have the same problem on a C450, only happens during B/W copying.
So far we have replaced the sensors (PC11/PC36), K PC Drum drive assy, PWB-MC & PWB-MFP but have not solved the problem.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.