PDA

View Full Version : C6500 C-2720


Custom Search


Haroldbfix
04-18-2009, 12:10 AM
Constant code during the warm up process. The HV/2, separation blocks, transfer rollers, separation plate and PRCB has been replaced. I checked for arcing no visible signs or smell of arcing.The machine only has 500K on it. This one is kicking my butt!:eek::eek::eek::eek:

This is what the manual says:
When the second transfer was
ON, second transfer abnormality
detection signal was continuously
detected for the specified
time.
High voltage unit/2 (HV/2)
Second transfer roller

Any ideas?

Setright
04-18-2009, 09:12 PM
Is the machine earthed?

Is that that little brass/copper earth connection on the transfer roller in good condition?

HORSE
04-19-2009, 06:02 AM
Also check on the secondary Tx roller that the hole on the shaft is toward the back of the machine.....

Haroldbfix
04-19-2009, 11:43 PM
Is the machine earthed?

Is that that little brass/copper earth connection on the transfer roller in good condition?
Yes its clean and in good condition.

Haroldbfix
04-20-2009, 09:30 PM
The problem was resolved today, I replace the HV/2 again!
According to tech support another guy had to replace the HV/2 twice also.

One done, one million to go!

Setright
04-22-2009, 02:00 PM
Good info.

Sometimes we need to remind ourselves that even brand new parts can have defects...even if it is counter-intuitive :D

HORSE
04-22-2009, 02:26 PM
indeed...... some of us have learnt the hard way.

Custom Search