PDA

View Full Version : change Fiery software from Xerox to KM on X3e


Custom Search


resolute
04-18-2009, 05:27 PM
Does anyone know if i can swap my fiery software. i have a dead RIP for my KM C500 and the dealer wants a lot of money to replace it. I have an X3e RIP that we had when we originally bought a xerox 240 - but we upgraded the rip so i have this extra one. On paper they are the same RIP. Can I just install the fiery software from KM and make that one work in my KM? I dont have the software from Xerox.. so if I do this and it doesnt work.. i'm out the rip, which considering what happend to the KM rip.. I think I dont want to take the chance without some reassurance. Thanks

pepper38_cnd
04-18-2009, 07:02 PM
Is it possible that you could replace the hard drive and load the KonicaMinolta firmware, and if no joy, just put the old hard drive back in?

RockETop
04-19-2009, 02:34 AM
The BIOS is different. No soap.

buster68
04-20-2009, 02:16 PM
Rocket is correct. The BIOS is different from the KM and Xerox version of Fiery.

Custom Search