PDA

View Full Version : Ricoh AP3800c


Custom Search


toshiba
12-28-2006, 09:57 AM
Hi budddies,
How the color registration problem can be solved in rioch color laser printer AP3800c. PCUs and transfer belt is new.:(

suckis
01-15-2007, 01:36 AM
After replacing the transfer unit:
• Perform forced line position adjustment (SP5-993-002 or ‘Maintenance menu –
Color Registration - Auto Adjust’ in User Program mode),
• Print the 1-dot grid pattern on A3/11"x17" paper and check the color shift level.

rovar
10-02-2013, 07:25 PM
forced line process

Eric1968
10-02-2013, 07:44 PM
You'll first have to check what causes the line positioning to fail. Check SP5-993-007 and see what value is displayed and search the manual for the cause. Did you replace the whole ITB Assy, or just the belt itself? If you only replaced the belt it could be that the drive rollers aren't clean.

Debs1964
10-02-2013, 08:12 PM
forced line process

I think, perhaps, that this problem has been resolved at some point in the past 7 years :confused:

mikadonovan
10-02-2013, 08:53 PM
Hopefully they threw the printer in the dumpster. I haven't seen one in years, but I remember I didn't like them much.

slimslob
10-02-2013, 10:05 PM
I think, perhaps, that this problem has been resolved at some point in the past 7 years :confused:

Thank you Debs. It has been a while since this thread was started. Now how long will it take for it to migrate down a couple pages?

Debs1964
10-02-2013, 10:30 PM
Thank you Debs. It has been a while since this thread was started. Now how long will it take for it to migrate down a couple pages?

Quite a while if we keep replying to it :p

Eric1968
10-03-2013, 04:07 PM
I think, perhaps, that this problem has been resolved at some point in the past 7 years :confused:

Ooops, you got me there....

Custom Search